My plan was to use the weekend to sort out why the engine wasn't running properly, but it didn't turn out like that.
I started it up & it wasn't a happy engine at all, misfiring at idle & still refusing to rev, so I ordered a coil pack & a set of leads as a first step to find out what's wrong. So then I needed something else to do, so installed new side repeaters - yes, hardly essential I know.
The ones on the car were the square ones from the donor Fiesta & stuck out the side of the car. I wanted soething smaller so bought "push-in" LED jobs, you put a gromet in the hole, push the lamp into the grommet, all done.
But - the grommet pushes into an 18mm dia hole in an up to 5mm thick panel, the holes in the car were 22mm dia & the panel is 10mm thick. Not a problam for a man with a 3D printer, I drew up an adaptor ring, like a headed bush that would push into the car from the inside, the outer ends has a rib fo the grommet to grip, I glued it to the car & fitted the indicators. Wiring wisw the car already has an LED comparible flasher unit as the bulbs in the other lamps have been swapped for LEDs.