I was approached this morning by a man holding a piece of
black plastic in the shape of my centre mirror plinth / GoPro mount fresh off
the 3D printer – and I saw that it was good.
The finish around the GoPro “fingers” is a bit “steppy” due
to the limitations of the process for reproducing radii, but the (empty) GoPro
case I’d taken to work slid into it snugly and the nut fitted in the hex
socket and the bolt fitted and when tightened it gripped the GoPro
case without snapping off the fingers – Success!
If it’s not below freezing when I get home (frankly unlikely)
I’ll see if I can fit it to the dash top, though I’m unlikely to have the right
size bolts.
No comments:
Post a Comment